Anoto DP-201 Betriebsanweisung PDF herunterladen (Seite 8)

2. Gently push the reset hole on the pen with a paper clip or another pointed object. The pen

vibrates once when reset.

Master reset

You can reset the digital pen to the factory settings. All data and everything you have written or

drawn will be deleted from the pen memory.

1. Take off the cap.

2. Gently press the pen tip on a surface at the same time as you gently push the reset hole on

the pen with a paper clip or another pointed object.

3. Keep the pen pressed to the surface for 15 seconds (the indicators flash green). When the

reset is completed, two of the three indicators turn steady yellow.

4. Lift the pen from the surface. The pen vibrates three times.

Exchanging ink cartridge

To exchange the ink cartridge in the pen, follow the steps below. The ink cartridge should only be

removed when out of ink. Hold the pen in a horizontal position.

1. Use a pair of tongs to get a steady grip of the ink cartridge.

2. Pull the tongs away from the pen; the ink cartridge will slide out of the pen.

3. Slip a new ink cartridge into the pen by hand, until it cannot be pressed any further.

Only slip a new ink cartridge into the pen. An ink cartridge that has been removed may

never be replaced into the pen. Using a previously used ink cartridge could cause ink

leakage which may destroy the digital pen. Replace the used ink cartridge with a new one.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Keine Kommentare

Anoto DP-201 Betriebsanweisung Seite 8